'FEAT': command not understood. HELP

MadPinkZaebra

2005-11-04 13:53:14

When I try and connect is says:
''FEAT': command not understood.'
then further down it says:
550 -L: No such file or directory.

I looked on the help section and it mentioned that you can turn off the FEAT command in setting, but I couldn't find this setting anywhere.

Any suggestions??

Full transcript of the code below:

500 'FEAT': command not understood.
TYPE I
200 Type set to I.
REST 0
350 Restarting at 0. Send STORE or RETRIEVE to initiate transfer.
PWD
257 "/" is current directory.
PASV
227 Entering Passive Mode (**numbers ommited by madpinkzebra**)
Opening data connection to (**numbers ommited by madpinkzebra**)
LIST -L
550 -L: No such file or directory.
Automatic failover of data connection mode from "Passive Mode (PASV)" to "Active Mode (PORT)"

Aokromes

2005-11-04 18:50:14

Hi, ![[[ERRORFEAT][/ERRORFEAT]][/[ERRORFEAT][/ERRORFEAT]]][/[[ERRORFEAT][/ERRORFEAT]][/[ERRORFEAT][/ERRORFEAT]]] for the -L thing disable it at file listing.